Tension Arm And Botieot Sensor Installation - IBM 9348 Service Information

Tension Arm and BOTIEOT Sensor Installation
Note: Whether the BOT/EOT sensor is exchanged or the buffer arm is exchanged
but the good BOT/EOT sensor is kept, replacement remains the same.
Put the BOTIEOT sensor assembly
over the metal flag near the hub of
the tension arm.
Place the sensor in position by
placing the pin on the bottom of
the sensor into the hole on the
tension arm base plate.
Align the screw hole on the sensor
over the hole on the tension arm
base plate.
Once aligned, the sensor
assembly should go into the
depression in the tension arm
base plate.
2
Insert the assembly into the
casting.
Place the sensor cable (coming
out from the bottom of the arm)
directly through the hole.
Place the EOT/BOT cable (the
wider cable) next to the sensor
cable, through the gap in the
casting.
Chapter 3. Service Procedures
3-63