Table of Contents
Advertisement
INFO
*
Option
The tape unit contains statistics and configuration information in a battery powered
storage module. This storage module permits the information to be saved when the
tape unit is powered off. INFO mode permits the statistics logs and the configura-
tion information to be displayed. Use the following procedure to display this infor-
mation.
1. Press the Diagnostic Mode button. TEST is displayed to show that the tape unit
is in the diagnostic mode.
2. Select the INFO option by pressing the Enter button when INFO is displayed.
INFO 0 is displayed to show that the tape unit is in the INFO mode.
3. The number displayed is the INFO log number. Use the Diagnostic Select button
to select the log you want to see. Press Enter to see the log.
4. Toleave the INFO mode, press the Cancel button until INFO is displayed.
5. To leave the diagnostic mode, press the Cancel button or the Diagnostic Mode
button.
TEST
*
Option
The tape unit contains diagnostic tests to aid you when isolating a failure.
1. Press the Diagnostic Mode button. TEST is displayed to show that the tape unit
is in the diagnostic mode.
2. Select the TEST option by pressing the Enter button when TEST is displayed.
TEST 0 is displayed to show that the tape unit is in the TEST mode.
3. The number displayed is the diagnostic test number. Use the Diagnostic Select
button to select the test you want to run. Press Enter to run the test.
4. To leave the TEST
*
mode, press the Cancel button until TEST is displayed.
5. To leave the diagnostic mode, press the Cancel button or the Diagnostic Mode
button.
Note: When the tape unit is in diagnostic mode, the Online, Rewind, and
Unload/Open buttons may be used to make keying the test number easier.
Pressing the Online button decreases the number by 10.
Pressing the Rewind button increases or decreases the number by 100.
Pressing the Unload/Open button increases the number by 10.
CONF
*
Option
The tape unit contains statistics logs and configuration information in a battery
powered storage module. This storage module permits information to be saved
when the tape unit is powered off. CONF
*
mode permits this area of the storage
module to be changed. Configuration values are preset and should not be changed
unless you are instructed to change them. To change configuration values, perform
the following steps to change the storage module:
1. If the Online light is on, press the Online button to take the tape offline.
7
Press t h ~
n l l n n n p t l r . TcST
is
5
!R
. . .
the diagnostic mode.
3. Press the Diagnostic Select button until CONFk* is displayed.
A-4
9348
Service Information
Advertisement
Table of Contents
