Tape Lifter Removal - IBM 9348 Service Information

Tape Lifter Removal
Place the tape unit in the service
position; see "Placing the 9348 in
the Service Position" on page 3-1.
Warning: Do not loosen or
remove the screws on the head
plate assembly. These screws set
the head skew adjustment. This is
a factory adjustment only.
Remove the two wires from the
clips on the tape lifter solenoid.
Remove the two TORX (T25)
screws that hold the tape lifter in
place and remove the unit.
3-56
Service Information