Appendixc . Logs; Display And Clear Logs; Clear Logs; Display Logs - IBM 9348 Service Information

Appendix C. Logs
Display and Clear Logs
Clear Logs
1. Place the 9348 in the diagnostic mode; see "Diagnostic Mode" on page A-3.
2. Select the CONF* option; see "CONF
*
Option" on page A-4.
3. Select the clear measurements parameter t o be changed.
4. Select the value you want, and press the Enter button to change the value. (SET
xx will be displayed t o indicate the change.)
5. To leave this mode, press the Cancel button until CONF* is displayed.
6. To leave the diagnostic mode, press the Cancel button or the Option button.
Display Logs
1. Place the 9348 in the diagnostic mode; see "Diagnostic Mode" on page A-3.
2. Select the INFO* option; see "INFO
*
Option" on page A-4.
3. Select the measurement to display.
4. Select the value you want, and press the Enter button to change the value. (SET
xx will be displayed t o indicate the change.)
5. To leave this mode, press the Cancel button until INFO* is displayed.
6. To leave diagnostic mode, press the Cancel button or the Option button.
Error Log Information (INFO 0)
Viewing the Error Log
The error log saves the last 30 errors and exception conditions. Because this infor-
mation is contained in the battery-powered storage module, the information is saved
through power-on and power-off cycles. To see this information follow these steps:
1. Place the tape unit in the diagnostic mode; see "Diagnostic Mode" on page A-3.
2. Select the INFO option; see "INFO
*
Option" on page A-4.
3. Select the error log by pressing the Enter button when INFO 0 is displayed.
4. The error recorded by the 9348 is shown when EXX YYY is displayed.
Note: XX is the error number from 01 through 30, with the largest number being
the newest error and 01 being the oldest error in the log. (The error displayed
can be changed by using the Diagnostic Select switch.) YYY is the error code
recorded.
5. To leave the INFO
*
mode, press the Cancel button until INFO* is shown.
6. To leave diagnostic mode, press the Cancel button o r the Diagnostic Mode
button.
O
Copyright IBM Corp.
1989,1992