Canon K1 Service Manual page 74

5
Adjustment > Adjustment at Time of Parts Replacement
9. Place A4-size paper on the inserter lower tray in the portrait orientation, and move the side guide
plates so that they touch the side edges of the paper.
10. Press the SW1 (to complete the fourth adjustment).
A4
■
Top cover positioning pin adjustment (after replacing the top
cover)
<Pre-check>
If you cannot lock the inserter top cover or it is difficult to lock it after replacing the top cover or top
cover unit, adjust the positioning pin following the procedure mentioned below.
<Adjustment method>
1. Remove the rear cover.
2. Increase the top cover open/close angle.
3. Loosen two screws [1] and one screw [2].
5
Adjustment > Adjustment at Time of Parts Replacement
A4R
F-5-17 F-5-17
4. Twist the top cover with both hands while twisting it slightly, and move the adjusting plate with
[1]
F-5-18 F-5-18
5. Close the top cover to check whether it closes smoothly. If it does not open/close smoothly, repeat
6. Tighten the three temporary jointed screws[1].
[2]
[1]
reference to the marks [3]. Next, secure the adjusting plate using a screw [2].
- Moving the mark [3] forward moves the positioning pin [4] backward.
- Moving the mark [3] backward moves the positioning pin [4] forward.
step 4.
[1]
F-5-19 F-5-19
F-5-20 F-5-20
5-6
5-6