Removing The Upper Tray Width Sensor (S10) - Canon K1 Service Manual

4
Parts Replacement/Cleaning Procedure > Removing the Sensor > Removing the Upper tray width sensor (S10)

Removing the Upper tray width sensor (S10)

5) Remove two screws to remove the tray lower cover (small).
1) Remove the rear cover.
(Refer to:4-9)
2) Increase the top cover open/
close angle.
(Refer to:4-9)
3) Remove the front cover.
(Refer to:4-10)
4) Remove the upper tray unit.
(Refer to:4-12)
6) Remove two screws and one connector to remove the upper tray width sensor.
MEMO:
After replacing with the upper tray width
sensor with a new one, adjust the sensor
output value in the service mode.
4 Parts Replacement/Cleaning Procedure > Removing the Sensor > Removing the Upper tray width sensor (S10)
x2
F-4-64 F-4-64
x2
4-28
4-28