Table of Contents
Advertisement
5
Adjustment > Adjustment at Time of Parts Replacement
4. Loosen the screw [3] and nut [2] that secure the right height adjusting mechanism.
5. Using an Allen wrench [1], turn the adjusting screw to adjust the gap between the right side of
the inserter pickup unit and the inserter base is within 1 mm at the front and back. Turning the
adjusting screw by one scale [4] mark (1 mm) moves the inserter pickup unit 1 mm upward/
downward.
- Turning the adjusting screw clockwise moves the inserter pickup unit upward.
- Turning the adjusting screw counterclockwise moves the downward.
6. Tighten the screw and hexagon nut.
7. Adjust the height of the left adjusting mechanism to the same mark as that of the right height
adjusting mechanism.
8. After completion of the adjustment, reassemble the disassembled parts.
5
Adjustment > Adjustment at Time of Parts Replacement
[1]
[2]
[4]
[3]
F-5-14
F-5-14
■
Document tray width adjustment (after replacing the document
width sensor)
1. Remove the rear cover.
2. Set the DIP switch as shown below, turn on the SW1 (push switch), and then turn on the
inserter.(Note: Keep pressing the SW1 for at least 2 seconds after turning on the power.)After
switching between modes, turn off the power and then turn it on again.
DIPSW（■ ON □ OFF）
1
2
3
4
5
6
■
□
■
□
□
□
LED1
LED2
SW1 SW2
SW3
ON
1 2 3 4 5 6 7 8
3. Place A4-size paper on the inserter upper tray in the landscape orientation, and move the side
guide plates so that they touch the side edges of the paper.
4. Press the SW1 (to complete the first adjustment).
5. Place A4-size paper on the inserter upper tray in the portrait orientation, and move the side guide
plates so that they touch the side edges of the paper.
6. Press the SW1 (to complete the second adjustment).
7. Place A4-size paper on the inserter lower tray in the landscape orientation, and move the side
guide plates so that they touch the side edges of the paper.
8. Press the SW1 (to complete the third adjustment).
Test mode
7
8
□
□
Tray control adjustment
F-5-15
F-5-15
[1]
[1]
A4R
A4
F-5-16
F-5-16
5-5
5-5
Advertisement
Table of Contents
