4
Parts Replacement/Cleaning Procedure > Removing the Sensor > Removing the Low tray last paper sensor 1 (S14)
8) Remove two screws to remove the tray lower cover (small).
x2
Removing the Low tray last paper sensor 1 (S14)
6) Remove four screws to remove the tray lower cover (large).
1) Remove the rear cover.
(Refer to:4-9)
2) Increase the top cover
open/close angle.
(Refer to:4-9)
3) Remove the front cover.
(Refer to:4-10)
4) Remove the upper tray unit.
(Refer to:4-12)
5) Remove the lower tray unit.
(Refer to:4-12)
4
Parts Replacement/Cleaning Procedure > Removing the Sensor > Removing the Low tray last paper sensor 1 (S14)
9) Remove two screws and one connector to remove the low tray width sensor.
MEMO:
After replacing with the low tray width sensor
with a new one, adjust the sensor output
value in the service mode.
F-4-73
F-4-73
x4
F-4-75
F-4-75
7) Remove four screws to remove the tray lower cover (inner).
x4
4-31
x2
F-4-74
F-4-74
F-4-76
F-4-76
4-31