Installation; Section 3 Installation; Introduction; Unpacking - ADB F-Range L-850C Manual

F-Range Type L-850C Style 3 Inset Lights
Section 3

Installation

1. Introduction

2. Unpacking

3. Input Requirement
Summary
 2006 ADB Airfield Solutions, Incorporated
All rights reserved
WARNING: Allow only qualified personnel to perform the
following tasks. Observe and follow the safety instructions
in this document and all other related documentation.
This section provides instructions for installing the L-850C F-Range
inset lights. Refer to airport project plans and specifications for the
specific installation instructions. The installation shall conform to the
applicable sections of the National Electric Code and local codes.
Each unit is individually packaged in a durable, cushioned, corrugated
cardboard carton. To avoid unnecessary damage to the light
assembly, unpack the carton at the installation site.
To unpack the carton, open the flaps and carefully remove the top
packing material. Thread an eyebolt into each of the two opposite
threaded holes. Run a rod through the eyebolts and lift the light
assembly from the shipping carton. Set the light assembly in a
protected area.
If damage to any equipment is noted, file a claim form with the
carrier immediately. The carrier may request to inspect the
equipment.
The F-Range light fixture is designed for connection to a 6.6 A or 20 A
series lighting circuit via an L-830 isolation transformer. Refer to
Specifications in the Description section for required isolation
transformers.
96A0285D
Issued 04/13
Installation
Page 3-1