Installation On L-868B Base; Figure 3-2 Installation On L-868B Light Base - ADB F-Range L-850C Manual

F-Range Type L-850C Style 3 Inset Lights
5. Installation on L-868B
Base

Figure 3-2 Installation on L-868B Light Base

1. Light Fitting
2. FAA Deep Base
3. Secondary Connectors
 2006 ADB Airfield Solutions, Incorporated
All rights reserved
The light assembly is shipped complete, including the lamp, and is
ready for installation.
To install the F-Range light fixture on the L-868B base, perform the
following procedure:
1. See Figure 3-2. Clean the base receptacle. Make sure that the
base receptacle does not contain water and is completely clean
and dry. The mating surfaces must be clean and free of foreign
particles.
NOTE: When using an L-868B bottom section and top section, a
minimum of 3-3/4-in. height must be used for the top section or
the fixture will not fit. This dimension does not account for
flange rings and/or spacers.
4. Rubber Grommet 7. Isolation Transformer
5. Conduit 8. Ground Lug
6. Spacer 9. Primary Connector
96A0285D
Issued 04/13
Installation
10. Screw, 3/8 in. or M10
Page 3-3