Figure 6-12 L-823 Cordset - ADB F-Range L-850C Manual

F-Range Type L-850C Style 3 Inset Lights
7. Replacing L-823 Cordset
(contd.)

Figure 6-12 L-823 Cordset

 2006 ADB Airfield Solutions, Incorporated
All rights reserved
3. See Figure 6-12. Remove both screws (F7) and the wire
clamp (F6).
NOTE: Replace the wire grommets (F5) when damaged or aged.
F9
4. See Figure 6-5. Unplug the fast-on connectors (7) from the cable
assembly.
5. See Figure 6-12. Pull the cordset cable assembly (F9) out of the
inner cover and discard the wire grommets (F5).
6. Bring the new cable assembly (F9) through the wire clamp (F6).
7. Put a new wire grommet (F5) on each of the wires, taking care of
the direction. Put the smaller diameter into the inner cover
recesses.
8. Install the wires in the inner cover.
9. Reinstall the wire clamp (F6) by means of both cross recessed
countersunk screws (F7).
NOTE: Do not torque down the screws entirely at this step.
10. Remove the insulation of the wires over about 5 mm.
11. Crimp on the new fast-on connectors and connect them to the
terminals. Adjust the wires inside the inner cover.
12. Torque the screws (F7) to 31  4 inch-pounds (3.5  0.5 Nt-m).
96A0285D
Issued 04/13
Repair
Page 6-15