Table of Contents
Advertisement
The RS-232 jack is reserved for software-development use only.
3.5 Installing the Power Supply
Follow the steps listed in Figure 3-6 to install the power supply.
1. Install a surge protector into the outlet or UPS
dedicated to your VP system.
2. Plug the DC power cord into the jack labeled PWR, on
the rear of the VP unit.
Voice Pro 2 x 6 Rear Panel
Voice Pro-206 Series Rear Panel
Ext15
3. Insert the Power supply unit into the surge protector or
UPS outlet.
Surge
protector
Ext14
Ext13
Ext12
Ext11
Power supply unit
Power
supply unit
Figure 3-6. Installing a surge protector.
NOTE
120 Volts
Reset
Music
RS232
Pwr
Ext10
Surge
protector
CHAPTER 3: Installation
Line 2
Line 1
Voice Pro
25
Advertisement
Table of Contents
