Black Box Voice Pro FX700A Manual page 16

Step 7: Connect a music source.
Use the included 6-ft. (1.8-m) cable with 3.5-mm headphone jacks at each end to
connect a music source to the Voice Pro. Connect one end of the cable to the
music jack on the Voice Pro and the other end to the music source (radio, CD
player, etc.).
Figure Q-9. Connecting a music source to the Voice Pro.
Step 8: Program the Voice Pro.
1. Connect the telephone lines and install the telephone extensions before
programming the Voice Pro.
2. From any station, lift the receiver and press the # key. You will hear the
automated voice say "Welcome to Voice Pro."
3. Enter the 4-digit default password (the default password is 1234), then enter
the # key.
4. Program the lines installed (press 2, then the # key).
a. If one line is installed, press 1, then the # key).
b. If two lines are installed, press 1, then 2, then the # key.
5. Set the clock.
While still in programming mode, press 1, then 9, then the # key.
Enter the hour, for example, 8 or 12—followed by the # key.
Enter the minute (2 digits; for example, 05 or 36) followed by the # key.
Ext 15 Ext 14 Ext 13 Ext 12 Ext 11 Ext 10 Music RS 232 Pwr
QUICK START GUIDE
Line 2 Line 1
15