Compaq AlphaServer DS10 Reference Manual page 193

4.14.16 set com1_mode
The set com1_mode command specifies the COM1 data flow
paths, so that data either passes through the RMC or bypasses it.
See Section 4.3 for descriptions of the RMC modes.
Syntax: set com1_mode value
where value can be:
Data partially bypasses the RMC, but the RMC taps into the
snoop
data lines and listens passively for the RMC escape sequence.
Data bypasses RMC, but the RMC switches automatically into
soft_bypass
snoop mode if an alert condition or loss of carrier occurs.
Data bypasses the RMC. The RMC is effectively disabled.
firm_bypass
Example:
444‡sˆÂqƒ!gƒrs
9QI!gIQ@AÂUPQQRÂUQBVg8aR7UUÂBETIg8aR7UU
Remote Management Console 4-31