Configuring Dial-Out Alert - Compaq AlphaServer DS10 Reference Manual

4.10 Configuring Dial-Out Alert

When you are not monitoring the system through a modem
connection, you can use the RMC dial-out alert feature to
remain informed of system status. If dial-out alert is enabled,
and the RMC detects alarm conditions within the managed
system, it can call a preset pager number.
You must configure remote dial-in for the dial-out feature to be enabled. See
Section 4.9. To set up the dial-out alert feature, enter the RMC from the local
serial terminal.
Example 4–2 Dial-Out Alert Configuration
TI94‡sˆÂrwi€
@wi€ÂUˆ†w‚u0Â7V`@V)!% (%%%####
TI94‡sˆÂi€s†ˆ
7€s†ˆÂUˆ†w‚u0Â% (%%%$$$$Æ1
TI94Âs‚ip€sÂi€s†ˆ
IƒrsÂ‘w€€ÂpsÂs‚ip€sr‘vs‚ÂwˆÂw‡Âqƒ‚‚sqˆsr
TI94Âq€si†Âi€s†ˆ
TI94‡s‚rÂi€s†ˆ
7€s†ˆÂrsˆsqˆsrÄ
ÆÂ
Disconnect the serial terminal and connect the modem at COM1 port.
ÆÂ
You should receive an alert within 30 minutes of modem connection.
# Once the alert is received, reconnect the serial terminal and clear the test alert.
TI94Âq€si†Âi€s†ˆ
TI94‡ˆiˆ‰‡
ÂÂ
7€s†ˆÂA‚ip€s0ÂA‚ip€sr
A typical alert situation might be as follows:
•
The RMC detects an alarm condition caused by excessive temperature.
•
The RMC dials the operator's pager and sends a message identifying the
system.
•
The operator dials the system from a remote serial terminal.
•
The operator invokes the RMC, checks system status, and powers down the
managed system.
4-14 DS10 Console Reference