Resetting The Rmc To Factory Defaults; Rmc Jumpers (Default Positions) - Compaq AlphaServer DS10 Reference Manual

4.12 Resetting the RMC to Factory Defaults

If the RMC escape sequence is set to something other than the
default, and the sequence has been lost or forgotten, the RMC
must be reset to factory settings to restore the default escape
sequence. See Appendix A.
Figure 4–7 RMC Jumpers (Default Positions)
RMC PIC
Processor
1
RMC
Jumper
WARNING: To prevent injury, access is limited to persons who have
appropriate technical training and experience. Such persons are expected
to understand the hazards of working within this equipment and take
measures to minimize danger to themselves or others.
4-18 DS10 Console Reference
PK0246c