Disable Remote; Enable Alert - Compaq AlphaServer DS10 Reference Manual

4.14.4 disable remote

The disable remote command disables remote access to the RMC
modem port and disables automatic dial-out alerts.
Syntax: disable remote

4.14.5 enable alert

The enable alert command enables the RMC to page a remote
system operator.
Before you can enter the enable alert command, you must configure remote
dial-in and call-out, set an RMC password (set password command), and
enable remote access (enable remote command) to the RMC modem port.
Syntax: enable alert
Example:
TI94‡sˆÂrwi€
@wi€ÂUˆ†w‚u0Âiˆ’rˆ)!% (%%%####
TI94‡sˆÂi€s†ˆ
7€s†ˆÂUˆ†w‚u0Â% (%%%$$$$Æ1
TI94Âs‚ip€sÂi€s†ˆ
The system notifies you that when you connect the modem (after disconnecting
the serial terminal at the COM1 port), the alert will be enabled. Before you
connect the modem, you can issue the status command to see if the Alert
Enable field is set to Enabled.
If the enable alert command fails, the following error message is displayed:
ÂATTQTÂÂs‚ip€sÂtiw€srÂ
.
4-24 DS10 Console Reference
IƒrsÂ‘w€€ÂpsÂs‚ip€sr‘vs‚ÂwˆÂw‡Âqƒ‚‚sqˆsr