Set Alert - Compaq AlphaServer DS10 Reference Manual

4.14.15 set alert

The set alert command sets the alert string that is transmitted
through the modem when an alert condition is detected.
Set the alert string to the phone number of the modem connected to the remote
system. The alert string is appended after the dial string, and the combined
string is sent to the modem.
The alert string cannot exceed 63 characters, and consists of the following
elements:
,,,,,, Each comma (,) provides a 2-second delay. In this example, a
delay of 12 seconds is set to allow the paging service to
answer.
5085554444#
A call-back number for the paging service. The alert string
must be terminated by the pound (#) character.
;
A semicolon (;) must be used to terminate the entire string.
The example shown below is generic. Because paging services vary, be sure to
listen to the options provided by the paging service to determine the appropriate
delay and the menu options.
Syntax: set alert
Example:
TI94‡sˆÂi€s†ˆ
i€s†ˆ4ÂÂ% (%%%!"!"Æ1
4-30 DS10 Console Reference