Download  Print this page

Lifting The Cabinet Off The Transport Pallet; Opening Doors In Preparation For Use - Siemens SINAMICS SM120 Operating Instructions & Installation Instructions

Motor module.
Hide thumbs

Advertisement

Preparations for use
4.4 Unpacking the cabinets
To extract the load securing device, proceed as follows:
1. Remove the retaining straps.
2. Remove the spacers such as wooden wedges, air cushions, etc.
4.4.3

Lifting the cabinet off the transport pallet

Use a crane to lower the transportation units from the transport pallets and transport them to
the installation site. Observe the guidelines described in the section "Transport with a crane."
4.4.4

Opening doors in preparation for use

NOTICE
Incorrectly opening the doors
If you incorrectly open the doors, then this can damage the locking mechanism.
● When opening the doors, follow the steps described.
● You must replace a damaged locking mechanism before commissioning, which will be
The drive is supplied in a closed state.
A label showing the operating steps and a screw marked by a further label are located on the
door. Under the screw you will find the opening for manually opening the doors.
60
charged for. Contact the service center in this regard. You can find the relevant contact
person under "Service & Support".
SINAMICS SM120 6SL38855?B
Operating Instructions 12/2015

Advertisement

Table of Contents

   Also See for Siemens SINAMICS SM120

   Related Manuals for Siemens SINAMICS SM120

Comments to this Manuals

Symbols: 0
Latest comments: