Transporting Transportation Units Packed In Boxes - Siemens SINAMICS SM120 Operating Instructions & Installation Instructions

Procedure
1. If there are several holes, select which holes to use based on the center of gravity.
2. Push the lifting rods through the holes.
3. Place the sling ropes on the lifting rods so they are close to the cabinet. Secure the ends
4. To lift the transport unit, use single sling ropes or two ropes with a cross stitch. Attach the
5. Lift the cabinet. Avoid shifting the center of gravity or distorting or damaging the cabinet.
4.3.7

Transporting transportation units packed in boxes

Transportation with the fork-lift truck
When the transport units are transported with a fork-lift truck, the force is absorbed through
the transport pallet. Observe the guidelines described in the section "Transport with a fork-lift
truck".
Transportation with the crane
Observe the guidelines described in the section "Transport with a crane". To protect the boxes
against pressure, use sufficiently long rope and a spreader beam. Please proceed as follows:
1. Attach the rope/cable to the pallet as shown in the following diagram.
2. Attach the rope/cable to the spreader beam
SINAMICS SM120 6SL38855?B
Operating Instructions 12/2015
Image 4-3 Lifting rod label
of the lifting rods using the splint.
Image 4-4 Securing the lifting rods
crane rope to the lifting rods so it is close to the cabinet.
When suspended, the cabinet must be parallel to the ground.
①
and the crane hook.
Preparations for use
4.3 Transport
57