Download  Print this page

Replacing Water Sensors; Image 9-10 Replacing The Water Sensors - Siemens SINAMICS SM120 Operating Instructions & Installation Instructions

Motor module.
Hide thumbs

Advertisement

Maintenance
9.7 Repair
9.7.7

Replacing water sensors

The sensors for detecting temperature, conductivity, and decreases in pressure are installed
in the water piping.
NOTICE
Device damage due to water
If water enters the cabinet while a water sensor is being replaced, this can result in material
damage.
Before replacing a water sensor, empty the entire water circuit and blow out the piping.
Removing a sensor
To remove a sensor, proceed as follows:
1. Loosen the screw in the sensor cover
2. Pull out the connector.
3. For the temperature sensor, loosen the two screws in the sensor cover
4. Remove the cables connected to the sensor.
5. Unscrew the sensor from the screw connection in the water pipe.
114
Image 9-10
Replacing the water sensors
.
.
SINAMICS SM120 6SL38855?B
Operating Instructions 12/2015

Advertisement

Table of Contents

   Also See for Siemens SINAMICS SM120

   Related Manuals for Siemens SINAMICS SM120

Comments to this Manuals

Symbols: 0
Latest comments: