Alarm Setting; Alarm Unsetting - jablotron 100 User Manual

6 OPERATING THE JABLOTRON 100 SYSTEM

Alarm Setting

1. PRESS
the segment button of the desired secti-
on. The button will start fl ashing red.
While setting the alarm, if any detector is active (e.g. an open window) the system will react (based on
system confi guration) in one of the following ways:
a
The system will be set regardless of the system status.
a
The system will optically indicate the system status for 8 seconds (fl ashing red) and sets automatically
once this period expires. Setting is also possible by repeatedly pressing the segment.
a
The system will optically indicate the system status for 8 seconds (fl ashing red) and can be set only
by repeatedly pressing the segment.
a
The triggered detector will inhibit the system from being set. In the case of an active detector with
the delayed reaction type, the system will optically indicate the system status for 8 seconds (fl ashing
red) and it can be set only by repeatedly pressing the segment.
Consult the installation with a technician in order to program the desired reaction for the system.

Alarm Unsetting

1. PRESS
the fl ashing button. Upon anyone ente-
ring the building the entry delay is trigge-
red. This is indicated with a continuous
tone and a fl ashing green button.
Note: If there is an entry delay in part of, or in the whole system, the alarm can be unset simply by
authorizing.
2. CONFIRM
the command by authorization – hold
the card or tag up to the reader or input
an access code.
2. CONFIRM
the command by authorization – hold
a card or tag up to the reader or input
an access code.
3. DONE
The command is executed and the
keypad acoustically indicates the exit
delay. Once the sound stops the relevant
section is set. The segment button turns
permanently red.
3. DONE
The command is executed and the seg-
ment button turns permanently green to
indicate an unset section.