Operating The System Remotely Usinga Computer (J-Link); Operating A Selected Programmable Output By Dialling-In; Blocking / Disabling The System; Blocking / Disabling Users - jablotron 100 User Manual

OPERATING THE JABLOTRON 100 SYSTEM
For example, you may choose SHUTTERS DOWN as your command to close the shutters on your win-
dows. It is also possible to eliminate the need for the CODE before the command. In such a case the com-
mand is simply authorized automatically when the system recognizes the user's phone number.
OPERATING THE SYSTEM REMOTELY USING
A COMPUTER (J-LINK)
The JABLOTRON 100 system can be operated both remotely and locally
on-site by installing the J-Link program on your computer. Users can also
be managed in this way (change codes, cards/tags, and phone numbers).
To operate the system remotely, the program must be downloaded from
the Downloads section of the www.jablotron.com website. The registration
number of the security system (a 14 digit code) and the telephone number
of its SIM card is needed to connect to the system. Remote access is initi-
ated by clicking on "Internet" in the main menu.
If the system uses a keypad with at least one controllable segment, then it
is possible to set/unset the appropriate sections using the on-screen J-Link
keypad (by clicking on "Keypad" in the main menu).
OPERATING A SELECTED PROGRAMMABLE
OUTPUT BY DIALLING-IN
Each telephone number stored in the system can control the system just
by dialling-in (i.e. without establishing a call). Dialling-in consists of dialling
the phone number of the SIM card used in the security system and hanging
up before the system answers the call. The system default is to answer the
phone after the third ring (approximately 15 seconds).

BLOCKING / DISABLING THE SYSTEM

BLOCKING / DISABLING USERS

Any user can be temporarily blocked (e.g. when a user loses their card/tag). When a user's access is
blocked their ID code or card/tag will no longer be accepted by the system. The user will also not be sent
any text message alerts or reports to their phone.
Only the system administrator or service technician can block a user. One method of taking away access
rights is by choosing Settings  Users  User  Bypass and selecting Yes on the LCD keypad. Another
option is to locally or remotely block a user through the J-Link program by clicking on the user in the
Settings  Users  User blocked column.
A blocked (disabled) user will be marked with a yellow (or red) circle until the user is re-established using
the same procedure.
11