Partial Alarm Setting; Terminating A Triggered Alarm - jablotron 100 User Manual

OPERATING THE JABLOTRON 100 SYSTEM

Partial Alarm Setting

1. PRESS
the segment button of the desired secti-
on. The button will fl ash yellow.
The system can also be partially set which allows only certain detectors to be triggered. For example, at
night only doors and windows can be triggered while motion detectors within a home can be disabled.
To set an entire system (all segments) in which partial arming is enabled, the button to set the system has
to be pressed twice. After the button is pressed once it fl ashes yellow, after it is pressed a second time it
fl ashes red.
If the system is already partially set – showing a continuous yellow light – the entire system can be set by
pressing the yellow button. Once authorized the entire system is set. Partial setting can be set up in a way
that authorization is not required.

Terminating a Triggered Alarm

1. PRESS
the segment button of the
triggered section. The button
will fl ash green.
If you happen to forget to unset the system and you unwittingly trigger the alarm, the keypad will fl ash
red, indicating an alarm in progress. Authorization will only silence the siren; the alarm is only cancelled
by unsetting the system. A rapidly fl ashing red light of a given segment indicates that the alarm is being,
or was, triggered. This continues to fl ash even after the alarm is unset. The system will similarly signal the
occurrence of an alarm triggered during your absence. If this happens, be very careful when entering and
checking the premises or wait until the security guard arrives (if your system is connected to an Alarm
Receiving Centre). The segment alarm indicator remains on until the system is set once again. Alternatively,
it can be cleared by unsetting the system one more time. With a keypad that has an LCD display the alarm
indicator can be cleared from the main menu - Clear alarm mem. Indication.
2. CONFIRM
the command by authorization – hold
a card or tag up to the reader or input
an access code.
2. CONFIRM
the command by authorizati-
on – hold a card or tag up to
the reader or input an access
code.
3. DONE
The command is executed and the seg-
ment button turns permanently yellow
to indicate a partially set section.
3. DONE
The command is executed.
The segment button turns
permanently green to indicate
an unset section. The red
segment button continues to
fl ash.
4. PRESS AND CONFIRM
once again to clear the alarm
memory indication.
5. DONE
The segment button turns
permanently green to indicate
an unset section.
7