Table of Contents
Advertisement
8-Printer Commands
ESC t – Set Print Direction in Page Mode
Description
ESC t sets the print direction and starting position in page mode specified by the
parameter n, as shown below. The default setting is n = 0. This command is enabled
only in page mode. If this command is entered in standard mode, an internal flag is
activated, and the command is enabled when the printer returns to page mode.
Commands that affect horizontal position (e.g. ESC $) and vertical
position (e.g. GS $) in page mode set the position relative to the print
direction set by this command, as illustrated below.
Expression
ASCII
[ESC] t <n>
Hexadecimal
1BH 74H <n>
Decimal
<27><116><n>
Parameters
n = parameter value ranging from
0-3, 48-51 per table below
100-14444 Rev B
Epic Edge™ OEM Integration Manual
n
Print Direction
0, 48
Left to right
1, 49
Bottom to top
2, 50
Right to left
3, 51
Top to bottom
August 2018
Starting Position
Upper left (A in figure)
Lower left (B in figure)
Lower right (C in figure)
Upper right (D in figure)
Page 101
Advertisement
Table of Contents
