Selecting A Channel; D Selecting An Operating Channel; D Selecting The Priority A Or B Channel; D Rewriting The Priority A Or B Channel - Icom IC-F1100D Series Operating Manual

Previous view
2
BASIC OPERATION

Selecting a channel

D Selecting an operating channel

To select a Zone:
z Rotate [Rotary Selector].
z Push [CH Up] or [CH Down].
<Voting operation>
The transceiver automatically starts scanning when a
Zone specified for the Voting operation is selected.
The Voting scan detects the signal strength of the
repeaters, and automatically selects the strongest
one.
<Automatic Scan operation>
Depending on the presetting, when the user turns ON
the transceiver, a scan automatically starts. The scan
stops when a call is received.

D Selecting the Priority A or B channel

Push [Prio A], [Prio A (Rewrite)], [Prior B], or
[Prio B (Rewrite)] to select the Priority A or Priority B
channel.

D Rewriting the Priority A or B channel

Hold down [Prio A (Rewrite)] or [Prio B (Rewrite)] for
1 second to set the currently selected channel as the
Priority A or B channel.

D Selecting a Continuous tone channel

In the Analog mode
<For the Simple key and Ten-key types>
1. Push [C.Tone CH Select] to enter the Continuous
Tone Channel selection mode. Then push [CH Up]
or [CH Down] to select a tone frequency/code.
2. After selecting, push [C.Tone CH Select] again to
set.

D Selecting a RAN channel

In the Digital mode
<For the Simple key and Ten-key types>
1. While in the Digital mode, push [Tone/RAN CH
Select] to enter the RAN CH selection mode.
2. Push [CH Up] or [CH Down] to select a RAN
channel.
• Sets the selected channel.
2-4