Icom IC-F1100D Series Operating Manual page 10

Previous view
1
PANEL DESCRIPTION
Assignable Software Key functions (Continued)
Disable
Set to disable the key.
NOTE: This key function is assignable to only
[Ext. Emer].
Null
No function.
Reset
In the Analog mode
Push to reset the destination station code to the
default, if it has been manually changed.
While in the Audible mode, push to return to the
Inaudible mode and automatically send a reset code
or Clear Down signal.
In the Digital mode
z Push to reset the destination Unit ID and call type to
the default, if they have been manually changed.
z Push to cancel the Talk Back function, if it is
activated.
z While in the selection mode (Message, Status
Message, and so on), push to return to the Standby
mode.
Shift
1. Push to enter the Shift mode.
• The Shift indicator is displayed.
L A user can use a Software Key's secondary function
in the Shift mode.
2. Push this key again to return to the Normal mode.
Category: Channel/Scan
Bandwidth
Push to temporarily set the bandwidth to Wide* or
Narrow.
L The wide bandwidth can be preset to either 25.0 kHz
(Wide) or 20.0 kHz (Mid).
Depending on the presetting, Middle may be selectable.
* The Wide bandwidth cannot be used in the USA version
transceivers.
CH Up, CH Down
z Push to select an operating channel.
z After pushing a Software Key, push to select an
option, setting, and so on.
C.Tone CH Select
Push to display the Continuous Tone Channel
selection mode. Then push [CH Up] or [CH Down] to
select a tone frequency or code. After selecting, push
this key again to save.
Encryption
Push to turn the Encryption function ON or OFF.
L The Voice or Data Encryption function provides private
communication between stations by using an Encryption
Key and Key ID.
High/Low
Push to select the transmit output power level
temporarily or permanently, depending on the
presetting.
Monitor
z Hold down to unmute the channel. (Audible mode)
z Push to enter the Inaudible mode.
z Activates the following function on each channel,
depending on the presetting.
L After the communication is finished, push to send a
'reset code' (5-Tone).
z Depending on the presetting, hold down for 1
second to cancel the scan.
NOTE: The audible (unmuted) mode may
automatically return to the Inaudible (muted)
mode, after the preset time period ends.
z Depending on the presetting, holding down this key
for 1 second may cancel the Scan.
1-8