Change Language - Danfoss AK-LM 330 Design Manual

Configuration - continued
Authorization
1. Go to Configuration menu
Press the orange setup button with the spanner at the bottom
of the display.
2. Select Authorization
3. Change setting for the user 'SUPV'
4. Select username and access code
5. Carry out a new login with the new user name and
the new access code
46 RS8FR302 © Danfoss 2015-08
When the controller is supplied it has been set to show the default
authorization for the different user interfaces. This setting should be
changed and adapted to the plant. The changes can be made now or
later.
You will use this button again and again whenever you want to get to
this display.
On the left-hand side are all the functions not shown yet. There will be
more here the further into the setup we go.
Press the line Authorization to get to the user setup display.
Mark the line with the user name SUPV.
Press the button Change
This is where you can select the supervisor for the specific system and a
corresponding access code for this person.
The controller will utilize the same language that is selected in the
service tool but only if the controller contains this language. If the
language is not contained in the controller, the settings and readings
will be shown in English.
To activate the display of the texts in the required language you must
carry out a new login to the controller with the user name SUPV and the
relevant access code.
You will access the login display by pressing the padlock at the top left
corner of the display.
AK-LM 330