Design Of A Monitoring; Procedure; Sketch - Danfoss AK-LM 330 Design Manual

Design of a monitoring

Procedure:

1. Make a sketch of the system in question
2. Check that the controller's functions cover the required
application
3. Consider the connections to be made
4. Use the planning table. / Note down the number of connections
./ add up
5. Are there enough connections on the controller module? – If
not, can they be obtained by changing an ON/OFF input signal
from voltage signal to contact signal, or will an extension
module be required?
6. Decide which extension modules are to be used
7. Check that the limitations are observed
8. Calculate the total length of modules
9. The modules are linked together
10. The connection sites are established
11. Draw a connection diagram or a key diagram
12. Size of supply voltage/transformer
1

Sketch

Make a sketch of the system in question.
30 RS8FR302 © Danfoss 2015-08
Follow these 12
steps
AK-LM 330