Parameter Clear - Toshiba B-FV4 Series Manual

6. SYSTEM MODE

6.2 Parameter Clear

By resetting your printer, you can return your printer to the state it was in when you receive it. This can help
you solve some problems caused by settings changed during the printing.
1. Turn off the printer.
2. Press and hold the [FEED] Button while turning on the printer.
3. Both status lights (LED 1 and LED 2) will light up in the following order:
Orange  Green  Other colour sequences
4. Release the [FEED] button when both lights turn to red.
5. Press and hold the [FEED] button for 3 seconds and release it. Both status lights blink red three
times, and turn to solid orange for a few seconds.
6. The printer will restore to default setting and reset automatically.
NOTE: In step 5, if you do not hold the [FEED] button long enough, LED 2 will blink orange three
times while LED 1 goes out. It means your printer is not reset.
Tone adjust value(Trans.)
Tone adjust value(Direct)
Feed adjust value
Cut adjust value
Backfeed adjust value
X-coordinate adjust value
Codepage
Zero Font
Euro Code
Control Code
Maxi Code Spec
Label Pitch
Effective print width
Effective print length
Print mode
Print speed
Print sensor select
Auto status response
Ribbon detect sensor
Feed key
Forward Feed Wait
Auto Calibration
Auto TPH check
PC save auto call mode
Multiple Label
BASIC Interpreter
Reserved item 1
Reserved item 2
Destination
Parameter
-3
0
0.0 mm
0.0 mm
0.0 mm
Not clear
PC-850
No slash
0xB0
Auto change Mode
TYPE1 (Normally)
76.2 mm
104.0 mm
74.2 mm
Continuity print
203 dpi : 5 ips / 300 dpi : 4 ips
Transmissive sensor
Disable
Not clear
Feed
Enable
Not clear
Disable
Flash memory
Disable
Disable
Not clear
Not clear
Not clear
6-3
6.2 Parameter Clear
Initial Setting
EO18-33030