Toshiba B-FV4 Series Manual page 129

6. SYSTEM MODE
1. Version Information
The firmware version and its build date.
2. Standard RAM
Total SDRAM size
3. Flash Type
The flash memory type and size.
4. H. Position Adjust
Move the print position horizontally.
5. Sensor Type
The media sensor type
It is see-through or reflective sensor.
6. Label-less Calibration Value
Check if a label-less calibration has been performed on your printer. If not, the value is 0000.
7. RTC Time
The date and time of the real-time clock (RTC)
The default format is month/day/year (hour:minute:second). If your printer has a built-in RTC, the RTC
time shows here.
8. Max Label Height
The max label length you can print at a time. For 200 dpi models, it is 100 inches; for 300 dpi models, it is
50 inches.
9. Print Width
The print width in dots
10. Lab Len (Top to Top)
For non-continues media, it is the length between the tops of two labels. You can also use the ZPL
command ^LL to define it. By default, it is 10 mm.
11. Speed
The speed of printing
The unit is inch per second (ips).
12. ABS. Darkness
The current darkness
You can use the ZPL command ~SD to define it.
13. Trim. Darkness
The adjustment of the current darkness
You can use the ZPL command ^MD to define it.
14. Print Method
It is direct thermal printing.
15. Print Length
The total print length
6-16
EO18-33030
6.5 Self-Test Printing / Dump Mode