3. REPLACING THE IMPORTANT PARTS
3.1.3 Replacing the Stepping Motor
1. Refer to Section 3.1.2 to remove the printer module.
2. Use a Phillips screwdriver to remove the 3 screws from the left side of the printer module.
3. Take off the stepping motor.
4.
Replace the stepping motor with a new one and then reassemble it in the reverse order of removal.
5.
After replacing, perform a diagnostic test print or print a sample label to make sure the printer is
performing correctly regarding the following points.
Printing is performed correctly.
No noise is generated during the print operation.
3.1 Replacing the Parts for B-FV4T-GS/TS
Screw
3-8
EO18-33030
Screw
Stepping Motor