If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Toshiba Tec service representative. 1. Precautions 3...
Page 5
NEVER USE THINNER OR ANY OTHER VOLATILE SOLVENT on the plastic covers. CAUTION! This manual may not be copied in whole or in part without the prior written permission of TOSHIBA TEC. The contents of this manual may be changed without notification.
2. Part Names and Accessories (1-slot Cradle) Part names Top side Bottom side [ 2 ] [ 1 ] [ 1 ] Name Name Charging terminal ACIN terminal Accessories [ 1 ] [ 2 ] [ 3 ] [ 4 ] Name Name...
3. Part Names and Accessories (4-slot Cradle) Part names Top side [ 1 ] [ 1 ] [ 2 ] Bottom side Name Name Charging terminal ACIN terminal Accessories [ 1 ] [ 2 ] [ 3 ] [ 4 ] Name Name...
4. Connecting the AC Adapter (1-slot Cradle) This section describes how to connect the AC adapter to a 1-slot cradle. Connect the plug of the AC adapter to the AC IN terminal of the cradle as shown in the figure. Orient the side of the plug with an arrow mark to the cradle side.
Page 9
Connect the power cable to the AC adapter. [ 3 ] [ 2 ] [ 1 ] Name AC adapter Power cable AC outlet 8 4. Connecting the AC Adapter (1-slot Cradle)
5. Connecting the AC Adapter (4-slot Cradle) This section describes how to connect the AC adapter to a 4-slot cradle. Connect the plug of the AC adapter to the AC IN terminal of the cradle as shown in the figure. Orient the side of the plug with an arrow mark to the cradle side.
Page 11
Connect the power cable to the AC adapter. [ 3 ] [ 2 ] [ 1 ] Name AC adapter Power cable AC outlet 10 5. Connecting the AC Adapter (4-slot Cradle)
6. Charging Charging is performed by placing a portable printer on the cradle. This section describes by taking a 1-slot cradle for the explanation purposes. Place the portable printer by aligning its charging terminal [2] to that for [1] the cradle. [ 2 ] [ 1 ] ...
When the problem still persists even if the following solutions have been performed, do not attempt to repair it by yourself. Disconnect the power cable and then contact a Toshiba Tec service representative for assistance. In the case of the following symptoms, check the respective points and take corrective action.
B-FP802-CR-CN-S Power requirements DC +19V, 3.42A (Supplied by the AC adapter) 100 to 240V AC, 50/60 Hz Output voltage DC+19V, 3.42A Application for TOSHIBA TEC battery pack TOSHIBA Battery Charger for B-FP803-BTH-QM-R B-EP800-CHG-QM-R B-FP802-CR-QM-S B-FP802-CR-CN-S Number of slots 1 slot Operating temperature 0°C to 40°C (32°F to 104°F)
9. When purchasing the power cord Certification Certification Certification Country Agency Country Agency Country Agency mark mark mark Australia Germany Sweden SEMKKO Switzerla Austria Ireland NSAI Belgium CEBEC Italy ASTA Canada Japan METI Netherla Denmark DEMKO KEMA U.S.A. Finland Norway NEMKO Europe France...