6.2
Parameter Setting on the Printer
For how to set the parameters, please refer to the Owner's Manual supplied with the connected TOSHIBA bar
code printer.
Note: The following example is the parameter setting procedure for the B-SX5T.
The "CENTRO. MODE" is set to "ECP" and "PLUG & PLAY" is set to "ON", respectively.
Power ON
ONLINE MODE
B-SX5T
[PAUSE]
PAUSE
B-SX5T
[RESTART]
<1>RESET
[FEED]
<2>PARAMETER SET
[PAUSE]
<2>PARAMETER SET
FONT CODE PC-850
[PAUSE]
<2>PARAMETER SET
CENTRO.MODE SPP
[PAUSE]
<2>PARAMETER SET
PLUG & PLAY OFF
[PAUSE]
<2>PARAMETER SET
[RESTART]
<1>RESET
[PAUSE]
ONLINE MODE
B-SX5T
The printer is in idle or printing.
V1.0A
(1) Press the [PAUSE] key.
The printer turns to the pause state.
V1.0A
(2) Hold down the [RESTART] key for 3 seconds or more.
The Reset menu is displayed.
(3) Press the [FEED] key.
The Parameter Setting menu is displayed.
(4) Press the [PAUSE] key.
(5) Press the [PAUSE] key until the "CENTRO.MODE SPP" is displayed.
Centronics interface operating mode selection
(6) Select the "ECP" by using the [FEED] or [RESTART] key.
(7) Press the [PAUSE] key.
Plug and Play selection
(8) Select the "ON" by using the [FEED] or [RESTART] key.
(9) Press the [PAUSE] key until the "<2>PARAMETER SET" is
displayed.
The Parameter Setting menu is displayed.
(10) Press the [RESTART] key.
The Reset menu is displayed.
(11) Press the [PAUSE] key.
The printer returns to the Online mode.
V1.0A
- 101 -