1. OUTLINE
1.6.2 Media Type (B-FV4D-GL)
The table below shows the size and shape of the media that can be used on this printer.
Label without liner
Cut position
B-FV4D-GL
Issue mode
Item
Label width
Cut length
Thickness
Max. outer roll diameter
Roll direction
Inner core diameter
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC approved media.
2. A label jam is more likely to occur with the approach of label end because labels around the paper core
curl intensely.
1.6.3 Detection Area of the Feed Gap (Transmissive) Sensor
The Transmissive sensor is fixed and positioned at 6.35 mm (for GS/TS Type) or 6.27 mm (for GH Type)
right of the centre of the media path.
The Transmissive Sensor detects a gap between labels, as illustrated below.
Sensor position
Min. 2 mm
(Min. 6 mm:
cut mode)
Feed Direction
Area to be detected
Label
Gap
Label
Min. 8 mm
Cut mode
102.0 (4.0)
25.4 to 152.4 (1.0 to 6.0)
0.06 to 0.19 (0.0024 to 0.0075)
Ø127 (5.0)
Outside wound
40.0 (1.57)
6.35 mm (for GS/TS Type)
6.27 mm (for GH Type)
1-23
EO18-33030
1.6 Supply Specifications
Unit: mm (inch)
Sensor position
Print side
Media feed direction