Step 4. Connect The Accessories - Keysight Technologies PNA Series Installation And Getting Started Manual

In This Guide
Installing Your Analyzer
In all installations, consider the following ventilation requirements when
deciding where to set up your analyzer.
Ventilation Requirements: When installing the product in a cabinet, the
convection into and out of the product must not be restricted. The ambient
temperature (outside the cabinet) must be less than the maximum
operating temperature of the instrument by 4°C for every 100 watts
dissipated in the cabinet. If the total power dissipated in the cabinet is
greater than 800 watts, then forced convection must be used.
Refer to the section below that applies to your installation.
To Install on a Bench Top
When you install the analyzer for bench top use, you may wish to attach the
supplied handles to the analyzer. If you wish to install the handles, follow the
instructions provided with the handle kit.
To Install in an Equipment Rack
(Option 1CP - Rack Mounting For Instruments Equipped With Handles)
(Option 1CM - Rack Mounting For Instruments Not Equipped With Handles)
When you install the analyzer in an equipment rack, you must install rails in the
rack to support the weight of the analyzer. Attach either the Option 1CP or
Option 1CM rack mount flanges to the analyzer. Secure the analyzer to the
equipment rack. Replace the analyzer bottom plastic feet with the hole plugs
provided.
For installation, follow the instructions provided with the rack mount kit and
the rail kit.

Step 4. Connect the Accessories

USB devices can be connected to any available USB port. All ports comply with
USB 2.0 specifications. The PNA will recognize the USB device when it is
connected and run the appropriate software driver to make the device operate
correctly. However, there is a limit to the amount of current that the PNA USB
ports can provide. See PNA Help - "USB port specifications" (index entry) for
more information.
The following is a list of USB devices commonly used with the PNA. Refer to
the Help that is embedded in the PNA for more information.
— Mouse - standard
— Keyboard - standard
— Printer (separate product)
— USB flash drive (separate product)
Installation Note E8356-90001 15