Install Spyware Protection; Use Agileupdate; Installing Your Analyzer; Overview Of The Installation Procedure - Keysight Technologies PNA Series Installation And Getting Started Manual

Network analyzers

Hide thumbs Also See for PNA Series:

Table of Contents

In This Guide

Install Spyware Protection

There is no anti-spyware software installed on the instrument. This should not

be a problem if you do not use the instrument for a lot of internet browsing.

Having spyware in the instrument could have an impact on the instrument

performance.

See also, "Windows 10 Operating System (B Models Only)" on page 22.

If your PNA is connected to the Internet, use AgileUpdate to obtain the latest

firmware. On the PNA, press System, then [Service] softkey, then [AgileUpdate]

to automatically update your firmware to the current revision.

If your PNA is NOT connected to the Internet, you must update firmware using

a flash drive. Firmware can be downloaded from

http://na.support.keysight.com/pna.

Installing Your Analyzer

This procedure requires an open or short calibration standard that mates

with the front panel test ports. The open or short calibration standard is

NOT included with the PNA.

"Step 1. Check the Shipment."

"Step 2. Meet Requirements."

"Step 3. Install the Analyzer."

"Step 4. Connect the Accessories."

"Step 5. Install Ferrite Cores."

"Step 6. Start Up the Analyzer."

"Step 7. Perform Administrative Tasks."

"Step 8. Run the Operator's Check."

"Step 9. Turn Off the Analyzer."

Installation Note E8356-90001

Table of Contents