Kjellberg SmartFocus 300 Short Instruction Manual page 72

Power source Smart Focus 300
9. LED-signal lamp green H30 „Temperature OK"
• LED ON:
10. LED signal lamp white H11 "Pilot arc"
• LED ON:
11. LED signal lamp white H10 "Main arc"
• LED ON:
12. potentiometer "cutting current "
adjustment of the cutting current (35 - 300 A) 5 A-steps
13. LED signal lamp yellow H31 "cumulative error gas, coolant, temperature"
• LED ON:
14. LED signal lamp yellow H32 "process error"
• LED ON:
15. potentiometer "marking current"
adjustment of marking current (10 - 50 A)
16. current display
• indicates cutting current (actual value)
• indicates cutting current (nominal value)
• indicates "error codes",see error chart / error codes
17. voltage display
• indicates the cutting voltage
• indicates "gas test"(6A5)
Pos : 17.67 /Steuer module--------------- Seitenumbr uch --------------- @ 0\mod_1197390577023_19.doc x @ 1454 @ @ 1
56
- Rectifier within the permissible thermal area
- main fan ON
pilot arc is ON
main arc is ON
- plasma cutting system not ready for operation
- indicates error through error codes at the current display (16)
- plasma cutting system not ready for operation cutting
- indicates error through error codes at the current display (16)