Kjellberg SmartFocus 300 Short Instruction Manual page 110

Plasma gas control unit FlowControl-300
Pos : 19.63 /Gas kons olen/FlowC ontrol/Fl owc ontrol-300/Anz eige Satz wechsel F 3 @ 14\mod_1418117704820_19.doc x @ 211397 @ @ 1
The display fast data set selection, activated by "F3", will be shown under the field PG1.
Set change with "F3" / Set "0" active (cutting set)
Fig. 30: Display "set change F3"
Pos : 19.64 /Gas kons olen/FlowC ontrol/Fl owc ontrol-300/Schnell e D atensatz wahl-Teil 4 @ 14\mod_1418117871257_19.doc x @ 211477 @ @ 1
3. Set selection through control cable of the CNC
In the operation screen "configuration data" at first the "fast data set selection over CNC" has to be active.
The stores "0" and "I" have been covered with the respective data sets (preferably "0" with the cutting record,
and "I" with the marking record).
With the first pressure of the button "F3" the fast data set selection will be active. From the guiding machine a
potential-free contact is required. At the interface X102 of the Smart Focus.
C3/C8 = connected, set of storage "I" loaded and
C3/C8 = interrupted, set of storage "0" loaded.
Purging takes place. If the assignment of the entry X102 (C3 - C8) will be changed, then the respective data
set will be loaded and purging takes place. Changes during the condition "Cutting, Purging and Purge error"
do not effect a data set change. The data set change takes place only at the condition "plasma stop".
Alterations of the stored data sets are not possible. For that the mode fast data set selection has to be
stopped with "F2".
Pos : 19.65 /Gas kons olen/FlowC ontrol/Fl owc ontrol-300/Anz eige Satz wechsel CNC @ 14\mod_1418117706146_19.doc x @ 211417 @ @ 1
The display fast data set selection, activated by "F3", will be shown under the field PG1.
Set change with CNC/ Entry power source
X102 (C3 - C8) disconnected
Fig. 31: Display "set change CNC"
Pos : 19.66 /Steuer module--------------- Seitenumbr uch --------------- @ 0\mod_1197390577023_19.doc x @ 1454 @ @ 1
94
Set change with "F3" / Set "I" active (marking set)
Set change with CNC/ Entry power source
X102 (C3 - C8) connected