Table of Contents
Advertisement
5.
Tumbler switch "Gas test"
upper position: gas test ON
• for adjusting the gas pressure
• for blowing out of the remaining drops of coolant after change of consumables
• LED signal lamp yellow H31 "cumulative error" (13) ON
• plasma cutting system not ready for operation cutting
6.
Tumbler switch "Gas pressure test"
Upper switch position: Gas pressure test ON
• LED signal lamp yellow "cumulative error" (13) and "Process error" (14) are ON
• solenoid valves are closed
• plasma cutting machine is not ready for cutting
Carry out the gas pressure test corresponding to the chapter "Maintenance special".
7.
LED-signal lamp green H29 "Coolant OK"
• LED ON:
8.
LED-signal lamp green H28 "Gas OK"
• LED ON:
cooling circuit operates (flow rateis o. k.)
pressure of plasma and swirl gases and also for control gas,
seecorresponding instruction manual of the gas console
Power source Smart Focus 300
55
Advertisement
Table of Contents
