Module Programming For Security-Only Installations - Directed DS4+ Installation Manual

Module programming for security-only installations

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
To connect the module:
Please ensure that the vehicle is in a safe location and cannot move forward during
1
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect all the harnesses to the DS4+, EXCEPT the 12-pin main power harness.
3
Connect the 12-pin main power harness, and wait until the LED turns ON solid orange.
4
Insert and turn the key to the ON position, and wait until the LED turns OFF.
5
Turn the key to the OFF position, and remove it from the ignition barrel.
Pair remotes (if applicable). For information on how to pair a specific remote, please
6
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
18
933.HKHT1 3.20.193.1 2012 Hyundai Accent
© 2019-03-20 Directed. All rights reserved.
Must be
connected LAST
Key OUT Key IN
START START
Connect all but the
12-pin harness
&
Solid
Key IN Key IN
&
START START
Off
Key OUT Key IN
START
Pair
remotes*