Soft Reset; Hard Reset - Directed DS4+ Installation Manual

Soft reset

A module reset will only erase the steps perfomed in "Module programming". The firmware and settings flashed to the module
will not be affected.
If required for your installation, connect all the harnesses to the DS4+, EXCEPT the 12-pin
1
main power harness. Press and hold the programming button, then connect the 12-pin
harness to the module.
Wait 3 seconds until the LED turns ON solid orange then release the programming button.
2
The LED turns ON solid red.

Hard reset

Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default factory settings. Depending on the installation, some settings (such
as RFTD and D2D options) may have to be reconfigured. Refer to <FeatureOptionList>.
If required for your installation, connect all the harnesses to the DS4+, EXCEPT the 12-pin
1
main power harness. Press and hold the programming button, then connect the 12-pin
harness to the module.
After 3 seconds the LED turns ON solid orange. Keep holding the programming button until
2
the LED flashes red, then orange slowly.
3
Release the programming button. The LED turns ON solid red.
21
933.HKHT1 3.20.193.1 2012 Hyundai Accent
© 2019-03-20 Directed. All rights reserved.
Connect all but the
12-pin harness
& &
Solid Solid
Release
Connect all but the
12-pin harness
& &
Solid Flashes
Hold
&
Solid
Release