Download
Share
Print this page
Directed Directechs DS4+ Installation Manual
  1. Manuals
  2. Brands
  3. Directed Manuals
  4. Automobile Accessories
  5. DS4+
  6. Installation manual
Directed Directechs DS4+ Installation Manual

Directed Directechs DS4+ Installation Manual

For honda7
Hide thumbs Also See for Directechs DS4+:

Advertisement

Quick Links

Download this manual
INSTALLATION GUIDE
HONDA7
Designed by Installers for Installers
© 2017 Directed, Vista CA
This product is intended for installation by a professional installer only! Attempts to install this
product by a person other than a trained professional may result in severe damage to a vehicle's
electrical system and components.
2017-06-21
DS4+

Advertisement

loading
Need help?

Need help?

Do you have a question about the Directechs DS4+ and is the answer not in the manual?

Questions and answers

Related Manuals for Directed Directechs DS4+

Summary of Contents for Directed Directechs DS4+

  • Page 1 HONDA7 Designed by Installers for Installers © 2017 Directed, Vista CA This product is intended for installation by a professional installer only! Attempts to install this product by a person other than a trained professional may result in severe damage to a vehicle’s electrical system and components.
  • Page 2 Contents Warning! Safety first ........................3 Introduction ............................ 4 Pre-installation and application warnings ..................4 Vehicle application guide ......................5 Wiring connections ......................... 6 Main harness (H1), 12-pin black connector .................. 6 Relay harness (H2), 10-pin white connector .................. 6 Data harness (H3), 8-pin white connector ..................
  • Page 3 The following safety warnings must be observed at all times: • Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. • When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an area that does not have adequate ventilation.
  • Page 4 White in pin 5 of the Black 12-pin harness. See "T-Harness modification procedure" on page 32. Additional parts required (maximum required): Resistor 100Ω Fuse 7.5A Diode 6A 0 x 1A Diodes 0 x Resistor 0 x Fuse 0 x Relay DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 5 DL: OE Door Lock & Alarm Controls FOB: Sync CAN Interface w/ FOB Remote PK: Transponder & Immobilizer Override RS: Remote Start & Engine Controls SS: Integrated Security & Monitoring ST: Function/Feature Status DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 6 Violet/Brown No Connection H3/7 Orange/Black No Connection H3/8 Yellow/Black Immobilizer Data If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 7 If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. Note that they are low current and a relay may be necessary. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 8 10-pin T-Harness wiring NOT White shown in the diagram Connector is NOT used with this installation type. Slide DS4+ to open It is important to check that the fuses are positioned correctly. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 9 Slide (+) 12V: pin 1 DS4+ (+) Ignition Input/Output: Pink: 10 to open (+) Starter: (+) Acc.: pin 4 pin 5 It is important to check that the fuses are positioned correctly. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 10 Immo Data Lt. Green Data Immobilizer Control Unit right of steering column under ignition switch. Gray Parking Lights Gray Headlight switch. White F-CAN High White Data OBDII. White F-CAN Low Data OBDII. White DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 11 Immo Data Blue Data Immobilizer Control Unit right of steering column under ignition switch. Gray Parking Lights Gray Headlight switch. White F-CAN High White Data OBDII. White F-CAN Low Data OBDII. White DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 12 Proper Fuse Positioning T-Harness wiring NOT shown in the diagram is NOT used with this installation type. Slide DS4+ to open It is important to check that the fuses are positioned correctly. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 13 (+) 12V : Red: 6 & 12 (+) 12V Input: Lt. Green/Red: 7 (+) Ignition Output: Lt. Green: 8 (-) Ground: Black: 10 Slide DS4+ to open It is important to check that the fuses are positioned correctly. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 14 Keyless Access Control Unit left of steering column. White Keyless Access Control Unit left of steering column. Immo. Data Gray Data Keyless Access Control Unit left of steering column. Green Keyless Access Control Unit left of steering column. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 15 Keyless Access Control Unit above glove box Gray Keyless Access Control Unit above glove box Gray Immo. Data Yellow Data Keyless Access Control Unit above glove box Gray Brown Keyless Access Control Unit above glove box Gray DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 16 Proper Fuse Positioning T-Harness wiring NOT shown in the diagram is NOT used with this installation type. Slide DS4+ to open It is important to check that the fuses are positioned correctly. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 17 (+) Ignition Output: Lt. Green: 8 (-) Ground: Black: 10 (-) Parking Lights: pin 8 Headlight Switch (White conn. at headlight switch) Slide DS4+ to open It is important to check that the fuses are positioned correctly. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 18 Gray Lt. Blue Keyless Access Control Unit behind instrument cluster. Gray Starter Green Keyless Access Control Unit behind instrument cluster. Gray Ignition Interrupt White Keyless Access Control Unit behind instrument cluster. Gray DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 19 Proper Fuse Positioning T-Harness wiring NOT shown in the diagram is NOT used with this installation type. Slide DS4+ to open It is important to check that the fuses are positioned correctly. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 20 (-) Parking Lights: (-) Ground: Black: 10 pin 8 Headlight Switch (Blue or White conn. at Headlight switvh) Slide DS4+ to open It is important to check that the fuses are positioned correctly. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 21 Keyless Access Control Unit behind glove box. Gray Ignition Pink Keyless Access Control Unit behind glove box. Gray Gray Keyless Access Control Unit behind glove box. Gray Starter Lt. Blue Keyless Access Control Unit behind glove box. Gray DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 22 Keyless Access Control Unit behind glove box. Gray Ignition Violet Keyless Access Control Unit behind glove box. Gray Gray Keyless Access Control Unit behind glove box. Gray Starter Lt. Blue Keyless Access Control Unit behind glove box. Gray DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 23 Keyless Access Control Unit behind glove box. Gray Ignition Blue Keyless Access Control Unit behind glove box. Gray Brown Keyless Access Control Unit behind glove box. Gray Starter Green Keyless Access Control Unit behind glove box. Gray DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 24 Proper Fuse Positioning T-Harness wiring NOT shown in the diagram is NOT used with this installation type. Slide DS4+ to open It is important to check that the fuses are positioned correctly. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 25 It is important to check that the Ignition: fuses are positioned correctly. Yellow, pin 2 10 9 8 7 6 5 4 3 19 18 17 16 15 14 13 Rear of Dash Fuse Box DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 26 Yellow Rear of dash fuse box. Blue 24-pin T-harness conn. Keyless Access Control Unit right of steering column. Blue Gray 28-pin T-harness conn. Keyless Access Control Unit right of steering column. Gray DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 27 Locating components in the vehicle Top Connector Middle Connector Under Dash Fuse Box front DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 28 21 It is important to check that the fuses are positioned correctly. (+) Starter: Ignition: (+) Acc.: (-) PTS: Yellow, pin 6 Pink, Gray, Black, pin 2 pin 32 pin 9 DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 29 White Gray Parking Lights Gray Gray Accessory Gray Black Black Black Starter Yellow Gray Ignition Interrupt Pink Gray B-CAN High Pink Data Blue B-CAN Low Blue Data Blue Immo. Data Data Gray DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 30 21 It is important to check that the fuses are positioned correctly. (+) Starter: Ignition: (+) Acc.: (-) PTS: Yellow, pin 6 Gray, Gray, Black, pin 2 pin 32 pin 9 DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 31 Parking Lights Gray Gray Accessory Gray Black Black Black Starter Yellow Gray Ignition Interrupt Gray Gray B-CAN High Pink Data Blue B-CAN Low Blue Data Blue Immo. Data Lt. Green Data Gray DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 32 Any first-time user must re-register to gain access to Key2GO, and some additional information will be required to complete the registration process, such as your Directed account number and store name. Key2GO is compatible with XKLoader2 and the online web tool, as well as XKLoader3 and the Directechs Mobile application.
  • Page 33 SmartStart. To ensure proper functionality with SmartStart, it is important that it is selected in the system programming of the DirectLink application or via the online web tool. Note: Both black D2D ports are reserved for the Control Center (antenna) and 8504D Combo Sensor. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 34 Analog Installation Guide, which can be found on tachometer www.directechs.com. * Your aftermarket remote may differ from the model shown in the illustrations. You have successfully completed the module programming sequence. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 35 Analog Installation Guide, which can be found on tachometer www.directechs.com. * Your aftermarket remote may differ from the model shown in the illustrations. You have successfully completed the module programming sequence DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 36 External module synchronization Description Troubleshooting OBDII feature not supported. The diagnostic data bus was not detected, therefore the SmartStart features will be limited. (Flashes red, red, then orange) x 10 DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 37 The vehicle was detected as moving, which prevents the system from shutting it down. Flashes red x 4 Analog error codes Description Troubleshooting DEI feature error. A feature config file mismatch was detected. Please contact Technical Support. Flashes red, green & orange DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 38 After 3 seconds the LED turns ON solid orange. Keep holding the programming button until & & the LED flashes red, then orange slowly. Solid Hold Flashes Release the programming button. The LED turns ON solid red. & Release Solid DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 39 Important! After successfully learning Virtual Tach, a small minority of vehicle starters may over crank or under crank during remote start. Use the VirtualTach Fine tune feature in the configuration wizard to adjust the starter output time in 50mS increments to compensate for such an occurrence. DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.
  • Page 40 Directed dealer, the unit was professionally installed and serviced by an authorized Directed dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed dealer; and the unit is returned to Directed, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer’s name, telephone number and address;...
  • Page 41 The application enables a “Cloud-Connected Car” like never before, providing * Icon and remote appearance may differ depending on the model purchased. 2-way interaction with your vehicle. Connectivity is managed through the Directed Cloud Services (DCS) network linking car, app, end user, and the Internet.
  • Page 42 Notes DS4+ HONDA7 © 2017-06-21 Directed. All rights reserved.