Table of Contents
Advertisement
4 - System setup
Automatic Swath Control (AutoSectionControl)
Settings
The Automatic Swath Control feature turns
sections off and on automatically based upon the
following conditions:
• Entering and exiting internal and outer field
boundaries.
• Entering and exiting previously-applied areas
within a field.
Automatic Swath Control can be toggled on/off by
the AutoSwath button on the lower right-hand
side of the Map screen.
To adjust AutoSwath settings, go to the
Configuration Settings screen, press the Automatic
Swath Control button. At the screen that appears,
options are:
• Outside Boundary Option
Select one of the two options to determine
system behavior when a section exits a field boundary.
• Coverage Option
In the Coverage Option area, you must choose between three options:
• Minimize Skip
Turns off the implement section after the entire section is fully inside your coverage area.
This prevents the possibility of skips.
• Minimize Overlap
Turns off the implement section when that section first enters your coverage area.
This prevents the possibility of overlaps.
• User Defined
Allows you to choose what percentage of the implement section is within the coverage area before that section
turns off. For example, if you choose 50%, then the section will switch off when half of it is within your coverage
area.
• Turn-On Look Ahead
Determines how far ahead the system looks
to turn the sections back on. This
compensates for delay in the system when
the sprayer sections are turned on.
• Turn-Off Look Ahead
Determines how far ahead the system looks
to turn the sections off. This compensates for
delay in the system when the sections are
turned off.
90
Configuration
Automatic Swath
Settings
Planting
Outside Boundary Option
Keep Unchanged
Turn Section Off
Control
Automatic Swath Control
Application
Coverage Option
Minimize Skip
Minimize Overlap
User Defined
Look Ahead Settings
Turn-On:
Look-Ahead
Settings
Turn-Off:
Advertisement
Table of Contents
