Table of Contents
Advertisement
Tank Mix Setup
A tank mix can contain up to seven individual components.
1. Select
2. Select "Tank Mix" from the list box and press
Define By
• Total amounts.
Mix/blend defined by amounts added to the tank (total of each product in tank).
• Rate/acre.
Mix/blend defined by the amounts applied per acre (rate of each product applied/area).
3. Enter a Base Amount and Units.
• Total Amounts.
Tank/Bin Size.
• Rate/acre.
For Rate Applied per acre.
4. Select Carrier.
• Press
to create a new carrier.
NOTE! The Base Amount is the total volume of all the components of the tank mix. The Base Amount does not need
÷
to match the actual volume of product that will be sprayed, but is used only to establish the ratio of all products to
the total volume.
5. Press
by the Add Mix/Blend Contents box to start the process of adding components to the mix.
6. Select a desired mix component from the drop-down menu.
NOTE! More than 7 products can be part of a template, but only 7 or fewer can be active at the same time.
÷
• A new product can be set up at this time by pressing
• Press
to add selected product, or press
product.
7. Press
to add an additional product.
8. When all components have been added press
9. Enter Manufacturer name if applicable.
• Manufacturer name can be added to the drop-down menu by pressing
10. Press
to enter a unique name for the mix/blend.
• Press
to complete the process of setting up the mix/blend, or press
Configuration Setup screen without adding a mix.
The product mix/blend appears under the Application heading located on the Product tab of the Configuration Setup
screen.
Represents Product Templates
Product
to continue.
and following the Product Setup Wizard.
to return to Add Mix/Blend screen without adding a
.
4 - System setup
Mix/Blend
.
to return to the
119
Advertisement
Table of Contents
