Hardi HC 9600 Operator's Manual page 116

4 - System setup
Nudge
NOTE! Only Straight patterns offer two Nudge settings. All other patterns have a single nudge setting.
÷
Nudge allows you to adjust the swaths by a specified distance for the direction of travel.
• Small Nudge (single arrow) shown on left.
Straight
• Large Nudge setting (double arrow) shown on right (Straight Patterns Only).
Reset
Nudge: 15 in
• Use Nudge toggle button
Total: 0 in
Large Nudge setting.
Use Mapping Toolbox toggle button
Toolbox, if Tramlines are enabled.
To make adjustments to Nudge settings:
When at the Nudge tab:
• Press to enter a distance for
increment that the swaths will move with
each successive press of the left or right
arrows buttons on the Guidance Tab.
• To clear out the adjustment and go to the
original position, press Clear Nudge.
Screen shows Small and Large increment settings
for Straight path. Other Patterns will only show the
small increment setting.
114
Nudge: 30 in
to switch the menu between Tramline and Nudge on the Mapping
Nudge
to switch between Small and
Total: 0 in
Guidance Options
Nudge Shift Lightbar
Save
Save
Group
Small Increment:
Pause
Large Increment:
Remark A
Total Nudge:
Straight
Reset
Nudge: 30 in
Total: 0 in
Clear Nudge