Menu 2.3 Vra/Remote Control; Variable Rate Application (Vra) / Remote / Hardi Autosectioncontrol - Hardi HC5500 Instruction Book

Menu 2.3 VRA/Remote control

Variable Rate Application (VRA) / Remote / HARDI AutoSectionControl

If the volume rate is to come from an external source (e.g. a site specific application map or a remote sensor), this menu has
to be enabled.
The symbol on the 1st line will be visible. Manual pressure regulation and stepped over/under application is still possible.
The external source is connected to the COM 1 or COM 2 via a 9 pin sub D connector.
The baud rate for the equipment should be set at one of the following before transmitting data:
• 19200 baud
• 9600 baud (HC 5500 default)
• 4800 baud
• 2400 baud
• 1200 baud
μ
ATTENTION! The COM port may have to be set up in the extended menu. Contact your HARDI service centre.
μ
ATTENTION! Use of HARDI AutoSectionControl requires a sprayer equipped with JobCom computer. If in doubt
whether your sprayer has a JobCom installed, please contact your local HARDI dealer.
6 - Menu 2 Setup
33