Waas/Egnos Settings; Terrastar Settings - Hardi HC 9600 Operator's Manual

WAAS/EGNOS Settings

PRN
• Automatic
• WAAS
• EGNOS
• Custom
ATTENTION! Should be left on Automatic
μ
unless otherwise told by support.

TerraStar Settings

• Serial Number
This box shows the serial number of your
receiver - used to purchase TerraStar
subscription.
• Automatic Tuning check box
Receiver will automatically select the
strongest frequency. Frequency drop-down
box will be grayed out when this is selected.
• Frequency
In the Frequency drop-down list box, select
the geographic region where you are
located. Only uncheck automatic tuning
when directed to by support (used to adjust
tuning).
• Convergence Threshold
The receiver uses the standard deviation of the solution to determine when the TerraStar position has converged. The
receiver will label the TerraStar solution as "converged" when the horizontal standard deviation reaches the
Convergence Threshold setting. Relaxing the convergence threshold shortens the time before a TerraStar solution is
reported as converged. However, it does not alter the absolute behavior of the solution.
NOTE! The use of TerraStar® differential requires purchase of a subscription from your HARDI® dealer. Settings related
÷
to using satellite differential correction vary based upon your geographic location. Setup details are explained on the
following pages. More specific information can be obtained through your HARDI® dealer. You will need to know the
serial number when contacting HARDI® to set up the receiver.
Receiver: GPS 6500
Serial
Receiver: GPS 6500
Serial
Serial Number
4 - System setup
Differential Source
General WASS/EGNOS
WAAS/EGNOS Settings
PRN
Automatic
Differential Source
General TerraStar
TerraStar Settings
Provider Settings
Automatic Tuning
Frequency
Convergence
Threshold
95