Hardi HC 9600 Operator's Manual page 133

3. Select Column From Shape File
Select the column that contains the product
recommendation rate. The list on the right
side of the dialogue shows sample data from
the selected column.
4. Select Units
Select the controlling units for product
application.
5. Default Rate Setting
The system assigns a default rate. Use the on-
screen keypad to edit the value if desired.
WARNING! Select the product and units that
±
the shape file prescription was made for.
Selection of the wrong data column or unit
will result in misapplication of product.
ATTENTION! The only time the default rate is used by the system during product application is if the Rate Outside of
μ
Field selection is set to "Rx default". This setting is located in the equipment configuration settings portion of
configuration setup.
If the Rate Outside of Field selection is set to "Rx default", the default target rate will be used when the vehicle exits
the area covered in the prescription map.
Import Prescription: Select Column
Column: Column Preview
Tgt_Rate_g
Product:
Units:
pounds
Default Rate:
4 - System setup
131