Advertisement
INSTRUMENT PANEL
System of treatment of exhaust gases - setting
The regeneration of the diesel particulate filter in case of increased temperature of exhaust gases is
performed at higher engine load. The system of regeneration of the diesel particulate filter DPF can be
controlled through the menu of the engine setting on the instrument panel. The regeneration can be
controlled in two modes. The mode of automatic regeneration of the diesel particulate filter and inhibition of
regeneration of the DPF filter (for safety reasons only).
Note: Setting of individual modes is described in Chapter System of Treatment of Exhaust Gases.
Instrument panel - warning
Replenish fuel
When the fuel signal lamp (orange) is lit up, the prompt to
refill the fuel appears in the display for about 3 seconds. If
the fuel is not refilled, the prompt always appears in the
display when the key is moved from the position ´0´ to the
position ´I´ for about 3 seconds. The fuel signal lamp is
permanently on.
P18N094
Add urea
P18N030
The amount of urea in the tank is displayed on the instrument panel on the main screen.
a - If the urea level is higher than 50%, it is displayed as OK on the instrument panel. If the amount is below
50%, the real amount of urea in percentage is displayed.
b - Small amount of urea in the tank is indicated on the instrument panel by the red (1) or orange (2) signal
lamp of low urea level. The signal lamp of low urea level is activated simultaneously with the fault signal lamp
(4) or the stop signal lamp (3) on the instrument panel.
c - Simultaneously the prompt to add urea to the tank appears together with an acoustic signal.
Always refill the urea tank during refuelling.
71
Advertisement
